- #Easy power tools manual
- #Easy power tools portable
- #Easy power tools free
Keep good balance and proper footing at all times.If they are available, choose hand tools with double handles to permit easier holding and better manipulation of the tool.Select tools with rounded and smooth handles that can be gripped easily.Choose hand tools that have the center of gravity within or close to the handle.Choose tools with vibration-absorbing handles, like those covered with cork, rubber, plastic or plastic bonded to steel, to reduce hand-arm Select low-vibrating tools as far as possible.When there is a choice, select a tool of a low Ensure it is the right size and has sufficient power to do the job safely.
Read the tool manufacturer’s manual to understand the tool’s proper applications, limitations, operation and Only use accessories recommended by the manufactures.Startling a tool operator could end up causing an accident or Do not surprise or touch anyone who is operating a tool.Connections shall not be taken over water logged.Cords should be put in conduits or protected by placing planks on each side of Do not walk on or allow vehicles or other moving equipment to pass over unprotected power cords.Remove it from service and repair or discard if not Never use power tool with malfunctioning switch or part.
Follow good housekeeping practices – keep the work area free of clutter and debris that could be tripping or slipping. This will allow user to use both hands for better control of the tool and will help prevent injuries if a tool jams or binds in a work piece. Use clamps, a vice or other devices to hold and support the piece being worked on, when practical to do so. Whenever power tool is to be kept unattended even for short period its power supply shall be Also do not walk around with a plugged-in tool with the finger touching the switch. Avoid accidental starting by ensuring the tool is turned off before it is plugged in. Braided extension cables shall be used for all power tools to reduce the possibility of damage due to site conditions which could lead to electrocution. Cords(double rubber insulated type) and hoses should be laid safely to avoid damage and tripping hazards. The tools should be suspended to avoid falling on the tool operator, when working overhead position with heavy. Feed material only as fast as the tool is designed to accept to prevent excessive wear and decreased control. Avoid excessive force to make cutting tools cut faster. User shall secure the tool in elevated places, so that it will not fall if the cord or hose is. User shall always disconnect the tool from power source before maintenance & attaching accessories. The switch shall be free from any locking All portable power tools shall be equipped with spring-loaded switch (dead man switch) which will actuate only when pressed. The following safety precautions apply for all portable power tools- electrical, pneumatic, hydraulic etc which are covered : Also there is inherent hazards of the power source. Hazards of exposure to repetitive vibration/motion (repetitive strain injury). Dropping or rough handling can cause tools to. At the same time it is difficult to guard such equipment completely. It can easily come in contact with operator’s body. Power tools have inherent risk because of its extreme mobility. Portable power tools present hazards similar to stationary machines performing the same. Portable power tools are divided into five primary groups according to their power source, which are electrical, pneumatic, gasoline and hydraulic.
0 kommentar(er)
